Description & Specifications
Roller chain offset links also known as half links are used to add an additional link to a strand of chain.
- Heat Treated For Maximum Hardness
- Shot Peening For Longer Fatigue Resistance
- Pre Stretched to Minimize Elongation Overtime
- Meets ANSI Specifications
16B-3 Offset Link Dimensions
- Pitch (P):25.40mm
- Inner Width (b1):17.02mm
- Roller Diameter (d1):15.88mm
- Transverse Pitch (Pt):31.88mm
- Chain Material:Carbon/Alloy Steel
- Industry Standard:ISO 606, DIN 8187, BS 228
All dimensions listed are nominal values.
Installation
Connecting Link Installation Tips
Spring Clip Connecting Links:
The spring clip should be installed where the opening is facing away from the direction of travel. This will help prevent the spring clips from coming off. Like shown in the diagram to the right.
Careful not spread the clip opening too far apart. This can make the clip more prone to falling off.
Cotter Pin Connecting Links:
Cotter Pin Connecting Links The cotter pins pin legs should be spread about 60° apart. Like shown in the diagram to the left.
Never reuse cotter pins that have been taken off. Never use commercial cotter pins as these are usually not hardened.
Related Items
