#80ZP Zinc plated connecting link. Roller chain connecting links also known as master links are used to connect two ends of the roller chain together.
Pitch (P): 1"
Overall Width: (L): 1.348
Pin Diameter (d2): 0.312
Link Plate Height (h2): 0.820
Link Plate Thickness (T): 0.125
Heat Treated For Maximum Hardness
Shot Peening For Longer Fatigue Resistance
Pre Strechted to Minimize Elongation Overtime
Meets ANSI Specifications
Connecting Link Installation Tips
Spring Clip Connecting Links: The spring clip should be installed where the opening is facing away from the direction of travel. This will help prevent the spring clips from coming off. Like shown in the diagram to the right. Careful not spread the clip opening too far apart. This can make the clip more prone to falling off.
Cotter Pin Connecting Links: Cotter Pin Connecting Links The cotter pins pin legs should be spread about 60° apart. Like shown in the diagram to the left. Never reuse cotter pins that have been taken off. Never use commercial cotter pins as these are usually not hardened.