The #10B K1 attachments will fit any British Standard 10B roller chain. The K1 attachment has 2 bent tabs with a single hole per tab.
10B K1 Attachment Connecting Link Dimensions
Pin Diameter (d2):5.08mm
Link Plate Thickness (T):1.70mm
Tab Width (G):14.3mm
Centerline To Outer Attachment Width (W):44.60mm
Width To Center Hole (F):31.75mm
Attachment Hole Diameter (d4):5.3mm
Attachment Height (h4):10.31mm
Connecting Link Clip Type:Spring Clip
Industry Standard:ISO 606, DIN 8187, BS 228
All dimensions listed are nominal values.
Connecting Link Installation Tips
Spring Clip Connecting Links: The spring clip should be installed where the opening is facing away from the direction of travel. This will help prevent the spring clips from coming off. Like shown in the diagram to the right. Careful not spread the clip opening too far apart. This can make the clip more prone to falling off.
Cotter Pin Connecting Links: Cotter Pin Connecting Links The cotter pins pin legs should be spread about 60° apart. Like shown in the diagram to the left. Never reuse cotter pins that have been taken off. Never use commercial cotter pins as these are usually not hardened.